السلام عليكم ورحمة الله وبركاته
شوفتوا اخرة عمايلكم مع شركة ميكروتيك عملوا ايه النهاردة؟...
شايفين صورة الموضوع؟؟؟
اهو ده حال العديد من اصحاب الشبكات لما تنزل نسخة جديدة من شركة ميكروتيك ويخش يختارها لجهازه!!!
فجأة يجيله شكشوكة وسكسكة فى الحمبالايز والعين تحول وبدل مايستعين بترجمة جوجل بيشغل الجمجمة...
وماادراك ماتشغيل الجمجمة بقى ياريس...خد عندك بقى....
المهم...اخينا يشوف تحديث جديد وهو معاه روتر بورد750 يروح جايب التحديث بتاع 1100 ويسكعه وش للجهاز
طبعا الجهاز معدش تقوم له قومة خاااااااااااااااااااااااااالص ويروح مصوت على المنتديات والجروبات
ويقولك البوردة اللى حيلتى بااااااااااااااااااااااااااااظت...
بص بقى العفريتة ميكروتيك عملت لكم ايه النهاردة؟....
مميزات النسخة الجديدة
What's new in 6.7 (2013-Nov-29 13:37):
*) support Android usb tethering interface;
*) ipsec - added aes-gcm icv16 encryption mode;
*) wireless - improve rate selection for
nstreme protocol
*) poe - new poe controller firmware for
RB750UP and OmniTIK UPA;
*) ipsec - added aes-ctr encryption mode;
*) leds - inverted modem signal trigger,
now it will trigger when the signal level
rises above the treshold;
*) ipsec - added sha256 and sha512 support;
*) ipsec - proposal defaults changed to aes-128
and sha1 for both phase1 and phase2;
*) certificate - support ip, dns and email
subject alternative names;
*) dhcpv4 server - added REMOTE_ID option
variable for relayed packets;
*) ipsec - fix policy bypass on IPv6 gre,
ipip, eoip tunnels when policy
uses protocol filter;
*) userman - fix crash on tilera;
*) fixed hairpin nat on bridge with
use-ip-firewall=yes;
*) fixed vlan on bridge after
reboot having 00:00:00:00:00:00 mac address;
*) address-list - allow manually adding
timeoutable entries;
*) address-list - show dynamic entry timeout;
*) fixed l2mtu changing on
CCRs - could cause port flapping;
*) disabling/enabling ethernet ports did
not work properly on CCRs - could cause
port flapping;
*) fixed port flapping on CCR - could happen
when having other than only-hardware-queue
interface queue.
Note that having other interface queue than
only-hardware-queue dramatically
reduces performace, so should be avoided if possible;
*) support Android usb tethering interface;
*) ipsec - added aes-gcm icv16 encryption mode;
*) wireless - improve rate selection for
nstreme protocol
*) poe - new poe controller firmware for
RB750UP and OmniTIK UPA;
*) ipsec - added aes-ctr encryption mode;
*) leds - inverted modem signal trigger,
now it will trigger when the signal level
rises above the treshold;
*) ipsec - added sha256 and sha512 support;
*) ipsec - proposal defaults changed to aes-128
and sha1 for both phase1 and phase2;
*) certificate - support ip, dns and email
subject alternative names;
*) dhcpv4 server - added REMOTE_ID option
variable for relayed packets;
*) ipsec - fix policy bypass on IPv6 gre,
ipip, eoip tunnels when policy
uses protocol filter;
*) userman - fix crash on tilera;
*) fixed hairpin nat on bridge with
use-ip-firewall=yes;
*) fixed vlan on bridge after
reboot having 00:00:00:00:00:00 mac address;
*) address-list - allow manually adding
timeoutable entries;
*) address-list - show dynamic entry timeout;
*) fixed l2mtu changing on
CCRs - could cause port flapping;
*) disabling/enabling ethernet ports did
not work properly on CCRs - could cause
port flapping;
*) fixed port flapping on CCR - could happen
when having other than only-hardware-queue
interface queue.
Note that having other interface queue than
only-hardware-queue dramatically
reduces performace, so should be avoided if possible;
تحياتى لكم شادى سوفت
0 التعليقات:
إرسال تعليق